WolfVision VZ-8plus Manuel d'utilisateur télécharger pdf (Page 11)

Image Storing Commands

Page Dec.

Code

Hex.

Code

Command Description see

Notes

1 140 $8C Memory Store x This command sends “?” back and waits for

character input “1”-“9” for memory number. Then

the Memory stores (max. 3 seconds time for the

character input).

1 141 $8D Memory Recall x This command sends “?” back and waits for

character input “1”-“9” for memory number. Then

the Memory recalls (max. 3 seconds time for the

character input).

1 142 $8E Memory Off This command switches to the Live image.

1 143 $8F Snapshot This command stores one memory after the other

memory, until all 9 memories are stored.

15, 11

1 136 $88 Show All On/Off This command toggles the Show All mode.

(If this function is activated, the Visualizer is

showing all stored images on the screen at the

same time).

1 137 $89 Show All On This command switches the Show All Memories

mode On.

1 138 $8A Show All Off This command switches the Show All Memories

mode Off.

1 165 $A5 Erase Memory This command erases all stored memories. 16, 11

1 139 $8B Get Show All This function returns ‘1’+LF+CR if the Show All

memories mode is active and ‘0’+LF+CR if the

Show All memories mode is inactive.

0 215 $D7 Freeze On/Off This command toggles the Freeze-Mode

1 166 $A6 Freeze On This command freezes the current image.

1 167 $A7 Freeze Off This command switches from the frozen image to

live image

1 168 $A8 Get Freeze This function returns ‘1’+LF+CR if the Freeze

mode is active and ‘0’+LF+CR if the Freeze mode

is inactive.

T-01-04.RS232 Protocol VZ-8_plus_light.doc Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

WolfVision VZ-8plus Manuel d'utilisateur Page 11