WolfVision VZ-3 Manuel d'utilisateur télécharger pdf (Page 13)

Fixing the Visualizer onto the table

The Visualizer can be fixed with a , so that it can not be stolen. Follow the

instructions from the cable lock manual.

security cable T-bar lock

T-bar lock

(Kensington Lock)

slot for lock

Anti-theft

Technical Specifications are Subject to Change!

The Visualizer can also be fixed onto a table with the supplied table mounting set in order to minimize the

risk of theft. Maximum thickness of the table is 35mm [1.38"] and a free area of at least 620mm x 350mm

[24.4" x 18.8"] would be required. Drill a whole into the table on the desired position: Ø 42mm [1.65"].

1. Fold the unit to remove the cover.

2. Remove the original base plate by removing both screws (keep it for further use).

3. Place one adapter plate and both screws (M4x50 Torx20) and fix it with at least one nut. Place the

necessary cables and connect it (begin with the biggest connector; depending on installation,

place the cables first through the second adapter plate and the table-drilling).

4. Mount the cable shield (if desired) with the supplied screws (K22x8 countersunk Torx6).

5. Place the unit onto the table, the screws through the drilling and mount the second adapter plate

with washers and hex nuts.

6. Fold the unit to slide in the cover.

1 2 ... 8 9 10 11 12 13 14 15

Pas de commentaire

WolfVision VZ-3 Manuel d'utilisateur Page 13